Skip to main content
Type a word
Category of Technology / Product

ID : tm3005611027


Compact Planar Highly Efficient Antenna for WLAN Applications

A printed microstrip monopole is designed to be operated in WLAN frequency range, which is one of the most important data connectivity features required in mobile terminals. The antenna is designed in compact size and feed, with a parasitic and ground plane to replace large ground planes used in traditional monopole designs. Using a /4 transformer, the antenna is easily matched to any 50 transmission line and ports interface to RF front ends. The optimized design is fabricated onto low cost FR-4, a material widely used in the production of printed-circuit boards (PCBs). Such mature fabrication technology reduces inaccuracy risks and ensures consistency of measured results. Antenna return losses are less than -10 dB over the WLAN frequency range of 2.40 GHz - 2.48 GHz. This narrow band and yet efficient feature reduces the collection of other signals within the adjacent frequency spectrum. Radiation pattern of this antenna entailed a comparable gain and beamwidth against conventional monopole antenna.

Kuala Perlis Perlis

ID : tm3005811029


Embedded Linux Network Monitoring System (eLNMS)

For many years Internet and Intranet traffic monitoring application has been developed to be executed on personal computer (PC) with high processing power. Thus the benefit of low cost, small size and portability which embedded system has to offer has never been benefited by these kinds of applications. The emergence of embedded Linux had driven developers to take up the challenge of developing high processing power application on embedded Linux platform.This research describes the design and development of an Embedded Network Traffic Monitoring (ENTM) system based on single board computer (SBC) and an open source embedded Linux operating system (OS). The developed ENTMsystem is capable of probing network packets, analyze the probe data and display the results of the analyzed and raw data. This system is a handy device for network administrator in analyzing incoming and outgoing network traffic. The main hardware components of ENTM system are the TS-5400 SBC, LCD panel, keypad and Compact Flash (CF) card. The ENTM software system is composed of four modules namely System Control (SC), Network Packet probe (NPP), Packet Analysis (PA) and View Module (VM). The SC module act as an interface/menu to execute various functionalities of the system and the integration of external devices (Keypad and LCD panel) to the SBC. The NPP module capture packets from a network segment, extract the packets information and store them into a temporary data buffer for further analysis. The PA module keeps track of global and individual-host information into files for viewing. The VM is used to display the analyze data through any web browser. To ensure reliability and practicality, analysis of the system performance is significant. Thus, the ENTM system performance is compared against execution of the software on Desktop PC and Wireshark, a well known competitive network analyzer. The experimental results shows that the data capture and packet capture rates of ENTM system is very much identical (less than 0.5% variation) during execution on Desktop PC and Wireshark regardless of its low CPU speed and memory size. The results prove that ENTM design and implementation is highly competitive even though of the hardware specification has low processing power and memory.

Kuala Perlis Perlis

ID : tm3005911030


Embedded Prayer Time System

a) The product is used the GPS and Digital Compass to determine the prayer time and also the Qibla direction.
b) The function of this product is to compute five prayers time (Subuh, Zohor, Asar, Maghrib and Isya) and also included with Syuruk and Imsak.
c) The benefit of this product is to facilitate user (Muslims) to decide and to know their prayers time more accurately especially who are need to work outstation and also for those who are like to do any activities at outside of the countries.

Kuala Perlis Perlis

ID : tm3006611037


Multiband Rugged Bow Tie Antenna for Outdoor Application

Bow tie antenna are widely used because their exhibit a very low profile, small size, light weight, low cost, high efficiency and easy methods of fabrication and installation. This actractive rugged bow tie antenna design exhibits wide bandwidth and good radiation characterictis. Omni-directional antenna invented here have 65-89% efficiency with peak gain value is 3.8 dBi. and covers the 5 cellular bands. In general, the antenna is about 1.5 inches high, 5 inches in diameter, and built with a standard TNC male connector at the other end. The antenna will operate within any of the cellular bands between 806 MHz 960 MHz and 1710 MHz 2170 MHz, and should be built to operate in an outdoor environment. This antenna is for a low profile outdoor rugged antenna to be in typical outdoor applications such as ATM machines and vehicle installations.
The novelty comes from the antenna design, which is miniature for outdoor application and produce a linear, vertical polarization while the azimuth plane, (Horizontal) -3dB Beamwidth is omnidirectional. Out of the ordinary, the antenna was able to perform with great efficiency and obtain size reduction without ignoring bandwidth and gain.
This antenna is for a low profile outdoor rugged antenna to be in typical outdoor applications such as ATM machines and vehicle installations and will operate within any of the cellular bands between 806 MHz 960 MHz and 1710 MHz 2170 MHz.

Kuala Perlis Perlis

ID : tm3006711038


Network Eye

A portable network analyzer has been develop in this project. In runs on an embedded platform running Linux. This device enables real time traffic capture and storage. At the same time acts as a server to provide collected traffic statistics to enable network engineer to identify network problems. The collected data statistic is viewable using any web browser.

Kuala Perlis Perlis

ID : tm3006811039


Portable Fruit Maturity System

Non-destructive fruit maturity testing system utilising permittivity effect
High resolution DAQ capable of detecting 0.5 mV difference
Built in embedded system software to give real time result
Intelligence system approximating human pattern recognition
Light to move/operate and easy to use
The reason banana as fruit under test because its yearly round ability and easy visual inspection versus electronic maturity measurement

Kuala Perlis Perlis

ID : tm3006911040


Real-Time People Counting System

A first people counter systems based on image processing counting technology are introduce. This technology emitted zero radiation which is harmless to health compare to those with microwave sensor technology, harmful to human if expose in long period of time especially for staff nearby. Furthermore, the device is needed to generate and receive this way is highly expensive. Due to the motivation from above mention,problems and with the rapid advances in the field of image-processing these days, coupled with research into the requirements of economic type people counter, has lead us to developed real-time people counting system that that fulfill the needs and expectations of most demanding store, companies and organizations.

Kuala Perlis Perlis

ID : tm3007111042


The Design of Dielectric Loaded Helical Antenna for Local Area Network (WLAN) Applications

Helical antennas have been popular antenna configurations meant for various applications provided its simple structure. Studies on the best custom shape parameters dielectric loaded helical antenna for Access Point WLAN IEEE 802.11 b/g 2.4 GHz to 2.48 GHz applications had been done. It presents the investigation of a Novel helical antenna incorporated with Barium Strontium Titanate (BST). Methods and antenna assembly techniques are based on readings. Much scrutiny focuses on the parametric study of such antennas with the use of simulation tools CST Microwave Studio capable of performing multiple dimension parameter sweeps. The antenna impedance is optimized by varying the antenna geometrical parameters and the dielectric loading within transient solver. The antenna design is optimized for operation with two of the WLAN Access Points (APs) products already available in the market to determine its suitability, integration and as to provide an alternative piece to the manufacturers antennas arsenal. A helical antenna with a high permittivity dielectric loaded place in the middle of the helix is designed here should operate as the WLAN b/g Access Point. It is fed through a square flange jack SMA. The ground plane acts like a reflector is cut not bigger than 29 mm in radius. The antenna model resulted in producing higher gain than without incorporating BST as its dielectric.

Kuala Perlis Perlis

Displaying 1 - 8 of 8

To Register New Technology and Product Click Here